What is John Deere corn head grease?

FS Corn head Grease is an extreme pressure, polyurea thickened grease, formulated especially for use in corn head gear cases and most other slow moving gear box applications requiring an NLGI “0” grease. Corn head Grease will not leak from the gear case or drain from the gears during idle periods.

How do you grease a 643 corn head?

Remove the plug on top of the gear box and fill with grease from the bottom till you can see it where the plug came out. Take the plug out on top (right where the ears leave the stalk rolls). Pump corn head grease into the fitting on the bottom until it comes up into the plug hole.

How do you lubricate a gearbox?

The three most common methods of lubricating a gearbox include;

1. Grease Lubrication. Grease lubrication is most suitable for gearboxes that are open or closed and operate at a low speed.
2. Splash Lubrication. Oil splash lubrication is frequently used for helical, spur, and bevel gearboxes.
3. Spray Lubrication.
4. Conclusion.

What grade is corn head grease?

NLGI #0 grade
Corn Head Grease is a high quality multi-purpose, semi-fluid type grease available in an NLGI #0 grade. Although primarily applied in corn head lubrication, this product can be recommended for many applications in agriculture, automotive, construction and industrial environments.

What is OO grease?

Cotton Picker Spindle Grease is a smooth textured, corrosion preventive grease manufactured with a special low viscosity, low pour point base oil with a lithium thickener, as well as rust and oxidation inhibitors. …

Can you put grease in a gearbox?

Some amount of grease can be added to an oil-lubricated gearbox to reduce lubricant leakage or noise. The grease’s consistency is primarily determined by the concentration of the thickener in the formula. An NLGI #2 grease has a higher proportion of thickener than an NLGI #00 grease.

How often should you grease a combine?

Usually do the 50hrs every 4 days. Have a red combine so there are a lot of 200 and 400hr service ones and those get once a season. Was told that over greasing the high hour zerks can do more damage then under greasing.

Where do you grease a gear lubricant?

Grease lubrication can be used for industrial gearbox systems that are open or closed, as long as they run at low speeds. The grease must have the correct viscosity with good fluidity, especially when used in an enclosed unit. Grease lubrication should not be used for continuous operation or high load gear drives.

Do gears need to be lubricated?

There must be sufficient grease to do the job. However, too much grease can be harmful, particularly in an enclosed system. Excess grease will cause agitation, viscous drag and result in power loss. The rotating gears splash lubricant onto the gear system and bearings.

What is 000 grease used for?

Typically, semi-fluid greases such as NLGI #000 or #00 are recommended for small gearboxes that frequently are run to fail. This strategy simplifies maintenance practices by reducing the chance of a leak and the need to top up components.